Konica Minolta magicolor 5670 Series

Very pleased with printer, but this was a replacement because it was cheaper to buy a new printer (exactly the same as our previous one) than buy cartridges etc.

I've run the 5670EN for 3 weeks now and it's everything I hoped it would be in terms of performance & quality of output.

I knew these were good before I bought them. In theory they offer a low cost per page - but actually the image units don't last nearly as long as KM suggest. I think they claim 36000 prints or 3 lots os 12000 toner units - but we have not managed that...

Excellant machine only negetive comment is that the manuel is not user friendly. More Pictures would of helped.

Service was excellent and problems installing software for duplexing were solved by Konica Minolta Helpline. Print quality of machine excellent, the only query being that cost of some consumables, particularly transfer units, is very high and not...

The machine runs too hot and there is no way to turn the fuser temperature down as there is on my Oki machine by switching to a thinner paper setting. We are getting deformation of the paper by the heat. Apart from that it is performing very well...

This machine works well now, colours were all over the place when we started using it and then the yellow faild all together but the problems seem only to be due to toner settling during storage. Konica's helpline were very helpful and had the machine...

Engineer called out to fit new fuser unit.Some smudging on colours at times if printer gets hot.

Cheaper to throw away the old printer and buy a new one than to replace toners & print units. Print units do not last anywhere near as long as KM claim before streaking and smudging. Shaking the excess toner out of them gives a new lease of life.

This printer needed a new set of cartridges after 5500 A4 sheets printed at about 5%